Waterfall countertops that flow down the sides of an island or counter, with matched veining and tight miters.
A waterfall edge carries the countertop surface down the side of an island or peninsula to the floor, as if the stone were poured over the cabinet. Done well, the veining flows around the corner without a break, and the island looks like a solid block of stone. Done poorly, the miter shows and the pattern jumps. It is one of the most visible custom details in a kitchen. Homeowners in Nashville ask for waterfalls to make an island the centerpiece of the room.
We plan waterfalls before we cut: we choose slabs with enough length and pattern, mark how the veins will wrap and cut the top and the side panel from the same area of the slab. The corner is a mitered joint, cut at a precise angle and glued with color-matched adhesive and clamped until set. We plan supports so the panels are stable, and we check the floor and cabinet toe-kick so the stone sits right. We install, fill and polish the joint and clean the surface.
We cut the top and the panel from the same part of the slab so veining flows around the corner without jumping.
The corner joint is cut and glued with great care, and we use color-matched adhesive so the line almost disappears.
Full-height panels are heavy, so cabinets need good support and the panels need secure attachment and leveling.
Stone, quartz and porcelain can all do waterfalls, but patterns with strong veins need more planning, and bold patterns need more stone.
Drag the handle to compare.
BeforeAfterPattern flows around the corner.
Cut and joined precisely.
Top and side matched.
Cabinets and panels secured.
Fit to the room.
Nearly invisible lines.
Every topic has its own page with what to expect and how we approach it.
Top brandKohlerA maker of faucets, showers, sinks and bathroom products for kitchens and baths.Learn more Top brandBlancoA maker of kitchen sinks, faucets and accessories, with a compatible BLANCO UNIT system.Learn more Top brandElkayA maker of kitchen sinks, faucets and commercial stainless products, along with water products.Learn more Answer five questions about your counters, goals and timing to see which services to start with.
You tell us what you want or what your counters are doing, and we set an estimate visit that fits your day.
We look at your cabinets, layout and walls, talk through materials, edges, sinks and seams and note any prep that is needed.
You choose the material, slab and details, receive a plain written scope and approve it before anything is ordered or cut.
We template your cabinets exactly, then the countertops are cut, shaped and polished to fit, with openings made for your sink and cooktop.
We remove the old tops, set the new ones level, join the seams, seal where needed and set the sink and backsplash.
We clean up, haul away the old countertops if you asked, walk you through the finished work and explain how to care for it.
Yes, usually one extra panel per side and enough slab to match the pattern.
Yes. Many islands have one or two waterfall ends.
Quartz, granite, quartzite, marble and porcelain, depending on the design and pattern.
A good miter shows as a hairline. Strong veining is easier to hide than plain colors.
Yes, if the stone is supported properly and the corner is protected from impacts.
Kitchen Island CountertopsIsland tops with seating overhangs, waterfall ends, cooktops and sinks, planned for support and flow.Explore 
Countertop Edge ProfilesEased, beveled, bullnose, ogee, mitered and other edges, shaped and polished to match your style.Explore 
Quartz CountertopsEngineered quartz countertops with consistent patterns, low upkeep and a huge range of colors and finishes.Explore 
Quartzite CountertopsNatural quartzite countertops with marble-like veining and strong resistance to wear, heat and etching.Explore Tell us about your project and we will call you back to set up a visit.
Or call (615) 357-7797 to talk now.
